- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 98
Section 03 ENGINES
Subsection 04 (MAGNETO SYSTEM)
CAUTION: Use only M8 x 20 mm screws to bolt
puller to magneto flywheel. When a counter-
weight is installed on magneto flywheel use M8
x 30 mm screws.
A06E22B
1
2
TYPICAL
1. Tab in magneto housing opening
2. M8 screws
– Remove magneto flywheel nut, using a 30 mm
socket machined to 40 mm (1.580 in) outside
diameter by 16 mm (5/8 in) long.
NOTE: To correctly remove a threadlocked fasten-
er, first tap on the fastener to break threadlocker
bond. This will avoid thread breakage.
A03C1JB
420 876 080
1
TYPICAL
1. 30 mm socket
To remove magneto flywheel, install the crank-
shaft protector (P/N 420 876 557) on crankshaft
end. Screw the magneto puller (P/N 529 035 547)
into puller ring.
529 035 547
420 876 557
Tighten puller bolt and at the same time, tap on
bolt head using a hammer to release magneto fly-
wheel from its taper.
Installation
Clean crankshaft extension (taper) and apply Loc-
tite 243 (blue) (P/N 293 800 060) on taper, then po-
sition Woodruff key, magneto flywheel no. 1 and
lock washer on crankshaft.
Clean magneto flywheel nut threads and apply
Loctite 243 (blue) (P/N 293 800 060) then tighten
nut.
ENGINES TORQUE
377 and 552 105 N•m(77lbf•ft)
593, 593 HO,
593 HO SDI and
793 HO Power Tek
125 N•m(92lbf•ft)
At reassembly coat all electric connections except
Deutsch housings (waterproof housing) with sili-
cone dielectric grease (P/N 293 550 004) to pre-
vent corrosion or moisture penetration.
CAUTION: Do not use silicone «sealant»,this
product will corrode contacts. Do not apply sil-
icone dielectric grease on any Deutsch water-
proof housing otherwise housing seal will be
damaged.
Ignition Timing
Check as described in IGNITION TIMING.
mmr2005-071 77
Ваш отзыв будет первым