- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 137
Section 03 ENGINES
Subsection 06 (BOTTOM END)
A17C07A
1
A
2
3
1. Bearing
2. Feeler gauge
3. Plain oil seal
A. 1 mm (.040 in)
552 Engine
Put27to32mLofgreaseinasyringe.
With the syringe, fill in the PTO side ball bearings
of Isoflex grease as shown below.
A32CBGA
TYPICAL — BALLS COATED WITH A SEAM OF GREASE
CAUTION: Use only the recommended Isoflex
grease (P/N 293 550 021). Make sure not to
push Isoflex grease between outside bearing
race and half crankcase.
Crankcase Assembly
Crankcase halves nos.1 and 5 are factory matched
and therefore, are not interchangeable as single
halves.
IMPORTANT: The total assembly sequence, in-
cluding sealing compound spreading, screwing
and torquing of bolts according to the proper
sequence must be performed within 10 minutes.
Do not wait between each bolt torquing. All bolts
mustbetorquedinarow.
Before screwing both parts of crankcase, seal it
with Loctite 5910 (P/N 293 800 081).
NOTE: It is recommended to apply this specific
sealant as described here to get an uniform appli-
cation without lumps. If you do not use the roller
method, you may use your finger to uniformly dis-
tribute the sealant.
CAUTION: Do not use Loctite Primer N with
the Loctite 5910. Using these products or non
silicone-based sealant over a previously sealed
crankcase with Loctite 5910 will lead to poor
adhesion and possibly a leaking crankcase.
These products are chemically incompatibles.
Even after cleaning, the Loctite 5910 would
leave incompatible microscopic particles.
Use a plexiglass plate and apply some sealant on
it. Use a soft rubber roller (50 - 75 mm (2 - 3 in))
(available in arts products suppliers for printmak-
ing) and roll the sealant to get a thin uniform coat
on the plate (spread as necessary). When ready,
apply the sealant on crankcase mating surfaces.
F12R17A
mmr2005-073 117
Ваш отзыв будет первым