- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1069
Section 04 ENGINE (4-TEC)
Subsection 04 (LUBRICATION SYSTEM)
R1004motr56A
1
3
2
5
4 6
OIL FILTER HOUSING
Removal
First drain the lubrication system (refer to OIL
CHANGE).
Remove:
– oil tank (refer to OIL TANK)
– oil filter (refer to OIL FILTER)
– oil filter housing screws no. 3 and no. 4 and pull
oil filter housing no. 2.
2
R1004motr42A
1
1. Oil filter housing
2. Three screws
Inspection
Check the oil filter housing for cracks or other dam-
age.
Replace oil filter housing if damaged.
Installation
The installation is the opposite of the removal pro-
cedure. Pay attention to the following details.
NOTE: Always replace gasket no. 1.
Torque oil filter housing screws to 9 N•m
(80 lbf•in).
ENGINE OIL PRESSURE
REGULATOR
The oil pressure regulator is located on the engine
alternator side (behind ignition cover/pressure oil
pump cover).
1
R1004motr43A
1. Engine oil pressure regulator
NOTE: The oil pressure regulator system works
between 240 kPa (35 PSI) and 430 kPa (62 PSI).
Removal
Remove:
– water pump housing (refer to COOLING SYS-
TEM)
– ignition cover (refer to COOLING SYSTEM)
– oil pump cover no. 25 (refer to PRESSURE OIL
PUMP)
– O-ring no. 36, valve seat no. 35, pressure reg-
ulating piston no. 34 and spring no. 33.
Put a suitable Allen wrench or another 90° an-
gle tool under the engine oil pressure regulator.
By slight hammer blows against the Allen wrench
carefully drive out the oil pressure regulator.
mmr2005-024 201
Ваш отзыв будет первым