- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1198
Section 06 ENGINE MANAGEMENT (4-TEC)
Subsection 03 (COMPONENT INSPECTION AND ADJUSTMENT)
2
R1503motr207A
1 Pin 1 Pin 2
1200 W resistor
Pin 3
V
1. CAPS
2. Conductor
If the voltage is not good, replace the CAPS.
Replacement
Unscrew the retaining screw and replace the
CAPS. Ensure to reinstall O-ring.
Apply Loctite 243 (blue) on thread and torque to
6N•m(53lbf•in).
AIR TEMPERATURE SENSOR
(ATS)
1
A32C79A
AIR SILENCER
1. Air temperature sensor (ATS)
Resistance Test
Disconnect the plug connector from the ATS and
check the resistance of the sensor itself.
The resistance should be between 2280
and
2740
at 20°C(68°F).
Otherwise, replace the ATS.
If resistance tests good, reconnect the ATS and
disconnect the connector A from the ECM.
R1503motr186A
7
21
Using a multimeter, recheck resistance value be-
tween terminals 7 and 21.
If resistance value is correct, try a new ECM. Refer
to ECM REPLACEMENT procedures elsewhere in
this section.
If resistance value is incorrect, repair the connec-
tors or replace the wiring harness between ECM
connector and the ATS.
Replacement
Disconnect the connector of the ATS.
Pull ATS out and install the new one.
R1004motr164A
334 mmr2005-032
Ваш отзыв будет первым