Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 148
Section 03 ENGINES
Subsection 06 (BOTTOM END)
Use a plexiglass plate and apply some sealant on
it. Use a soft rubber roller (50 - 75 mm (2 - 3 in))
(available in arts products suppliers for printmak-
ing) and roll the sealant to get a thin uniform coat
on the plate (spread as necessary). When ready,
apply the sealant on crankcase mating surfaces.
F12R17A
F12R18A
Screw all crankcase bolts in place in the following
sequence and to the appropriate torque; this must
be done in two steps torquing: first, screw bolts
up to 60% of the final torque (18 N•m(13.5lbf•ft)
for most of the bolts), then, tighten to the required
torque (i.e. 29 N•m(21lbf•ft)).
11
A32C3FA
BA
9 14 4 1 16 5
8
18
12
10 13
2
3
15 6 7 17
19
B
20
B
21
B B
A. Torque bolts 1 through 16 to 29 N•m(21lbf•ft)
B. Torque bolts 17 through 21 to 9 N•m(80lbf•
in)
593 HO, 593 HO SDI and 793 HO Engines
Install oil seal cover.
BREAK-IN
After rebuilding an engine, always observe a
break-in period as described in Operator’s Guide.
128 mmr2005-073
Ваш отзыв будет первым