- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 916
Section 02 TROUBLESHOOTING GUIDE
Subsection 05 (ELECTRICAL SYSTEM)
Symptom: RER (ROTAX ELECTRONIC REVERSE) DOES NOT WORK.
1. Check idle speed.
- Wrong idle speed. Adjust according to specification (refer to TECHNICAL DATA).
2. Check spark plug.
- Faulty spark plug. Replace.
3. Check drive belt deflection.
- Wrong deflection. Adjust according to specification (refer to TECHNICAL DATA).
4. Check carburetor synchronization and air screw adjustment.
- Wrong adjustment. Adjust according to specification (refer to TECHNICAL DATA) and read car-
buretor subsection.
5. Check electrical connections.
- Bad electrical connections or damaged wires. Clean or replace.
6. Check MPEM.
- Faulty MPEM. Replace.
Symptom: RER (ROTAX ELECTRONIC REVERSE) DOES NOT WORK (AT HIGH ALTITUDE).
1. Check high altitude cap continuity.
- Broken jumper inside high altitude cap. Replace high altitude cap.
Symptom: HEADLAMP NOT LIGHTING (WHITE BULB).
1. Check bulb.
- Gas leak. Replace bulb.
Symptom: HEADLAMP NOT LIGHTING (BROKEN ELEMENT).
1. Check for loose headlamp housing and bulb socket.
- Vibration problem. Tighten headlamp mounting screws. Lock bulb in socket. Replace bulb.
Symptom: HEADLAMP NOT LIGHTING. (MELTED FILAMENT (ENDS OF ELEMENT HOLD-
ER) AND BLACK BULB.)
1. Check voltage at headlamp at different speeds. It must not be above 15 Vac. (If quartz
halogen bulb is involved, ensure that proper voltage regulator is installed).
- Excessive voltage in lighting circuit. Replace voltage regulator and ensure proper grounding.
Retest.
Symptom: HEADLAMP DIMING.
1. Check voltage at headlamp at different speeds. It must not be below 11 Vac.
- Insufficient voltage in lighting circuit. Replace voltage regulator and retest.
2. Visually inspect wiring harness for damaged and/or melted wires and/or bad wire terminal
crimping and/or connections.
- Heating, rotating or sharp part in contact with harness. Improper harness routing. Repair/replace
damaged wires and/or terminals. Reroute harness where necessary.
3. On manual start models: Verify regulator ground.
- Rusted or loose retaining screws. Clean, apply lithium grease (LMZ1) and firmly tighten screws.
40 mmr2005-008
Ваш отзыв будет первым