- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1191
Section 06 ENGINE MANAGEMENT (4-TEC)
Subsection 03 (COMPONENT INSPECTION AND ADJUSTMENT)
1
A32C7OA
1. Vehicle harness
Disconnect the wiring harness from all sensors/
actuators.
Disconnect the connector A from the ECM.
Cut all locking ties which are holding the wiring
harness in position.
1
R1004motr153A
1. Wiring harness
Remove complete wiring harness.
Installation
First connect the connector A to the ECM and the
engine connector to the vehicle wiring harness.
Now attach the engine wiring harness with a lock-
ing tie to the breather hose.
NOTE: Wiring harness is marked with a green
tape, where locking tie has to be installed.
1
R1004motr181A
2
1. Position of locking tie
2. Greenmark(tape)onwiringharness
Then connect CAPS. Ensure the cable is above the
breather hose, then fasten it with a locking tie.
Connect injector and ignition coil of cylinder 2 to
the wiring harness. Ensure that cables are under-
neath the fuel line.
Also connect the TPS, MAPS (grey connector) and
the idle bypass valve to the wiring harness.
Then connect injector and ignition coil of cylinder 1
to the wiring harness. Attach the cable with lock-
ing tie on the throttle cable bracket.
1
R1004motr155A
1. Locking tie
mmr2005-032 327
Ваш отзыв будет первым