- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 700
Section 05 ELECTRICAL SYSTEM
Subsection 05 (ACCESSORIES AND LIGHTING SYSTEM)
Disconnect headlamps.
On RH side of vehicle, remove the push nut then
remove the headlamp housing.
Installation
Reverse the removal procedure.
HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam
is 25 mm (1 in) below the headlamp horizontal cen-
ter line, scribed on a test surface, 381 cm (12 ft
6 in) away.
Place the vehicle on a flat surface perpendicular to
test surface (wall or screen) and 381 cm (12 ft 6 in)
away from it.
Rider or equivalent weight must be on the vehicle.
Select high beam.
Measure headlamp center distance from ground.
Scribe a line at this height on test surface (wall
or screen). Light beam center should be 25 mm
(1 in) below scribed line.
A02E0AA
1
B
90°
A
TYPICAL
1. Headlamp center line
A. 381cm(12ft6in)
B. 25 mm (1 in) below center line
A02E07A
2
A
1
3
1. Headlamp horizontal
2. Light beam (high beam) (projected on the wall)
3. Light beam center
A. 25 mm (1 in)
HEATING ELEMENTS
NOTE: All measurements must be performed at
21°C(70°F).
Throttle Lever Heating Element
Resistance Measurement
THROTTLE LEVER HEATING ELEMENT
TEST High Intensity Low Intensity
WIRE COLOR
BROWN and
YELLOW/BLACK
BROWN/YELLOW and
YELLOW/BLACK
RESISTANCE 1.73 to 4.22 5.73 to 18.54
NOTE — —
Handlebar Grip Heating Element
Resistance Measurement
HANDLEBAR GRIP HEATING ELEMENT
TEST High Intensity Low Intensity
WIRE COLOR
ORANGE/VIOLET and
BLACK
ORANGE and BLACK
RESISTANCE 17 to 23.5 8.5 to 11.8
NOTE
When measuring resistance at terminals the actual
value will be half the measurement in table. The
reason for that is the elements are connected
in parallel. Therefore the total resistance is half
the resistance of one element.
If the heating elements are good, check connec-
tors and wiring harness.
RELAY
Voltage Test
RELAY
TEST Coil Contact
WIRE COLOR
WHITE/GREEN and
BLACK
BLACK/YELLOW and BLACK
RESISTANCE — —
VOLTAGE 10.5 to 13.5 Vdc 00.0 to 0.10 Vdc
NOTE
Engine idling (1500 to
1600 RPM)
Engine idling (1500 to
1600 RPM)
mmr2005-130 181
Ваш отзыв будет первым