- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 947
Section 03 ENGINES (2-STROKE)
Subsection 02 (443 AND 552 ENGINES)
A32B0EA
CIRCLIP READY TO BE INSTALLED ON PISTON
Using a plastic hammer, tap pusher to insert circlip
in place. Take care to install new circlips with tab
toward top as per following photo.
A32C4BA
TAB TOWARD TOP
CAUTION: Always install new mono-hook cir-
clips. If circlip installation fails at the first at-
tempt, always retry with a new one as on a sec-
ond attempt circlip will lose its normal retain-
ing capabilities.
CAUTION: Circlips must not move freely after
installation; if so, replace them.
Clean cylinders and crankcase mating surfaces
with Loctite Chisel (P/N 413 708 500).
Coat crankcase mating surface with Loctite 518
(P/N 293 800 038). Choose the right gasket thick-
ness according to combustion chamber volume.
Refer to LEAK TEST AND ENGINE DIMENSION
MEASUREMENT. Install it on crankcase. Coat
gasket with Loctite 518.
CAUTION: Always install a gasket of the proper
thickness. Failure to do so may cause detona-
tion and severe engine damage.
All Engines
Before inserting piston in cylinder no. 4, lubricate
the cylinder with new injection oil or equivalent.
Install proper ring compressor on piston assembly.
ENGINE
RING COMPRESSOR
P/N
443 420 876 090
552 420 876 972
NOTE: The ring compressor will not fit on over
size pistons.
Check flatness of intake sockets no. 6. Refer to
ENGINE DIMENSION MEASUREMENT and look
for CHECKING SURFACE FLATNESS.
At cylinder no. 4 and/or cylinder head no. 3 instal-
lation, use aligning tool or exhaust manifold itself
to ensure sealing of intake manifold and exhaust
before tightening cylinder head nuts.
ENGINE ALIGNING TOOL P/N
443 and 552 420 876 171
A17C01A
420 876 171
mmr2005-011 73
Ваш отзыв будет первым