- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 573
Section02ENGINE
Subsection 06 (E-RAVE SYSTEM)
A35C0RA
WRONG
Insert cables in E-RAVE actuator pulley.
A35C0DA
Loosely install adjuster nuts. Do not tighten ad-
justers yet, proceed with adjustment as described
below.
Adjustment
IMPORTANT: Ensure all components are properly
installed to their operating position and that proper
routing of cable is achieved. Otherwise, improper
E-RAVE operation will result leading to poor engine
performance.
Remove DESS key and wait until lights of
speedometer turn off. ECM must be off.
NOTE: Ensure there is no VCK supply harness
connected to the EMS diagnostic connector.
Ensure cable adjusters and cable ends on E-RAVE
actuator pulley are loose.
A35C0FA
Turn E-RAVE shaft pulley clockwise to the Close
position.
A35C0GA
Remove the headlight relay (R2).
NOTE: To prevent battery discharge, headlight
fuse (F8) can be removed.
Bypass relay with a jumper. This will turn the
E-RAVE shaft pulley to the adjustment position.
NOTE: If pulley does not turn, E-RAVE actuator
was already in right position.
mmr2005-148 45
Ваш отзыв будет первым