- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 327
Section 07 ELECTRICAL SYSTEM
Subsection 04 (ACCESSORIES)
A continuous signal should be audible. If not, re-
place the relay.
If a signal is audible, apply 12 volts on terminals
85and86thenplacetheREDprobeonterminal
30 and the BLACK on the terminal 87.
A33E1LA
1
3
2
4
1. Terminal 30
2. Terminal 87
3. Terminal 85
4. Terminal 86
The continuous signal should be audible. If not,
replace the relay.
SPEEDOMETER
Removal
Insert a little flat screwdriver into the slot at the
bottom of the speedometer. Slightly, pry the
speedometer and turn it clockwise then remove
it from accessories panel.
Unplug connector.
Test
No lights and the needle does not move
Remove the speedometer. Apply 12 volts be-
tweenpin8andpin11. Placethepositiveprobe
onpin8andthenegativeonpin11.
NOTE: Respect positive and negative positions if
not the speedometer could be damaged.
A33E1PA
11 8
If the speedometer stays off, change it.
If the speedometer is lighted, check connector
and wiring harness. Repair defective parts.
The speedometer is lighted but the
needle does not move
Check the speed sensor and the wiring harness.
If the speed sensor and the wiring harness are
good, change the speedometer.
Installation
The installation is the reverse of the removal pro-
cedure.
SPEED SENSOR
Test
Fan-cooled Engines
To perform the speed sensor test, the engine
must turn.
Liquid-cooled Engines
Install the supply harness (P/N 529 035 869) with
the supply cable (P/N 529 035 997).
NOTE: Remove the headlight system fuse to save
the battery during the test.
All Models
Static Test
Unplug the speed sensor connector.
mmr2005-085 313
Ваш отзыв будет первым