- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1314
Section 08 ELECTRICAL
Subsection 05 (ELECTRIC STARTER)
A19E03A
1
2
1. Turn until bushing goes out
2. 12 mm tap
To install new bushing, use the same bushing
pusher as for drive housing bushing installation.
6, Brush
To replace brush no. 6, proceed as follows:
Cut brush wire close to connector at the welded
portion.
A19E05A
1
1. Cut close to connector
Remove burrs with a file on the remaining welded
portion.
CAUTION: Be careful not to damage plastic
portion of starter housing.
Place spare brush plate edge against housing con-
nector edge (welded portion).
Crimp plate over housing connector with a pair of
pliers.
A19E06A
1
2
3
4
1. Plate edge
2. Housing connector
3. Crimp
4. Spare brush
Solder the crimped portion.
CAUTION: Do not overheat and quickly per-
form soldering to prevent solder from flowing
to the brush through the wire. Preferably use
aheatsink.
593 and 593 HO SDI Engines
Before disassembling, trace index marks on
starter housing no. 10 and starter housing assem-
bly no. 8 to ease later assembly.
Remove starter through bolts no. 17. Separate
end frame housing no. 14 from starter housing
no. 10. Withdraw starter housing from armature
no. 11.
Brush holder no. 13 can be removed from end
frame housing no. 14 by disconnecting the end
frame attached brush from brush holder no. 13.
Check the radial play between the armature shaft
and end frame bearing. Replace the end frame
bearing or replace starter. If parts are in good con-
dition then coat with synthetic grease (P/N 413
711 500) before reinstalling them.
Push back the collar no. 3 using a screwdriver.
Remove snap ring no. 2. Remove collar no. 3 and
spring no. 4.
mmr2005-046 455
Ваш отзыв будет первым