Бесплатные инструкции на русском языке
  • Тип техники
  • Бренд

Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 208

Ski Doo
Section04FUELSYSTEM
Subsection 02 (CARBURETORS, THROTTLE AND CHOKE CABLES)
1
A32C6TB
1. Circlip
At throttle slide assembly, needle retainer must
face carburetor body.
1
A32C70A
2
1. Needle retainer
2. Ensure O-ring gasket is properly seated in nipple area
After inserting throttle slide cover in place and
before installing screws, ensure O-ring gasket is
properly seated in its groove especially in the area
around vent nipple. See illustration above.
INSTALLATION
Throttle/Oil Pump Cable
For installation, reverse the removal procedure.
To adjust throttle and oil pump cables see further
in this section.
Carburetors
CAUTION: Never allow throttle slide(s) to snap
shut.
Install throttle cable to cam lever no. 16.
Install choke cable to cam lever no. 4.
Install dual carburetor assembly.
Make sure dual carburetor assembly is proper-
ly inserted into intake adapters, hold it in place
and tighten retaining clamps.
Secure heated carburetor inlet and outlet
lines with clamps, tighten to 1.5 to 2.0 Nm
(13to18lbfin) and remove pincher on outlet
line.
Allow coolant to flow from coolant tank to carbu-
retor before opening valve.
Connect all hoses to dual carburetor assembly and
to DPM (if applicable), making sure there are no
kinked hoses after reconnection.
Reconnect TPS connector (Power Tek models).
Reinstall air intake silencer.
Make sure dual carburetor assembly properly
slides into air intake silencer adapters; hold it
in place and tighten clamps.
Non-DPM Models
Reconnect carburetor vent hose.
DPM Models
Reinstall DPM manifold in its support.
Reconnect air temperature sensor connector to air
intake silencer.
CARBURETOR ADJUSTMENTS
Adjustments should be performed following this
sequence:
pilot screw adjustment
carburetor synchronization and throttle slide
height (preliminary idle speed adjustment)
throttle cable adjustment
TPS reset (Power Tek engine)
idle speed adjustment (engine warmed up, all
components installed).
mmr2005-077 189
Ваш отзыв будет первым
Задайте вопрос
Ваше имя
E-mail
Вопрос*
Ваш вопрос будет опубликован после проверки
Ваш вопрос опубликован

Смотрите также другие инструкции раздела Снегоходы

Смотрите также другие инструкции раздела Ski Doo