Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1330
Section08ELECTRICAL
Subsection 06 (TESTING PROCEDURE)
– Connect multimeter probes to WHITE/BLUE
and BLACK wires coming out from module.
Place the selector switch to Vac and the scale
to 00.0.
A32E0ZA
TYPICAL
– Activate the manual starter and check values
indicated by the multimeter.
– Repeat operation 3 times.
– Compare readings with those appearing in the
IGNITION table.
7. HIGH VOLTAGE COIL TESTING
Liquid Cooled Engines
Resistance Testing
– Unplug housing between high tension coil and
MPEM.
– Connect multimeter probes to WHITE/BLUE
and BLACK wires and measure resistance.
A32E12A
– Compare readings with those appearing in the
IGNITION table.
Voltage Testing
– Disconnect spark plug cap from spark plug.
– Fasten alligator clip to spark plug cable, near the
spark plug.
– Connect other multimeter wire to engine
(ground), then place selector switch to Vac and
scale to 0.00.
1
A32E11A
2
1. MAG side spark plug cable
2. Connected to ground
– Activate the manual starter and check values
indicated by the multimeter.
– Repeat operation 3 times.
– Compare readings with those appearing in the
IGNITION table.
8. BUZZER TESTING
2-Stroke Engines
Using jumper wires, connect battery positive post
to buzzer positive tab.
Connect battery negative post to buzzer negative
tab.
CAUTION: To avoid buzzer damage, ensure
that polarity is respected.
472 mmr2005-047
Ваш отзыв будет первым