- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 367
Section 08 DRIVE SYSTEM
Subsection 05 (BRAKE)
Install the Banjo bolt no. 7 with two new sealing
rings no. 8.
Fasten caliper on chaincase. Do not forget to in-
stall and fold locking tab over caliper bolt.
Fill the brake system and bleed it. Refer to
BLEEDING at the end of this section.
The brake disc no. 10 must be centered in caliper.
Apply brake then check for proper brake disc po-
sitioning.
Push on appropriate caliper piston in order to
move pad inward allowing proper brake disc po-
sitioning.
1
A03D2KA
2
3
TYPICAL
1. Brake disc not centered
2. Brake disc centered
3. Apply brake before checking
Apply brake then recheck.
BRAKE PADS
Inspection
Brake pads no. 7 must be replaced when lining is
1 mm (1/32 in) thick or less or if the hollow place,
on lining pad, is not visible.
CAUTION: Brake pads must always be replaced
in pairs.
A
A30D1BA
A. 1 mm (1/32 in) minimum
Removal
Brake pads removal procedure is as follows:
– Remove 2 retainers no. 12 from the pins no. 13.
– Pull out the pins which releases the spring
no. 14.
1
2
A33D0TA
3 3
TYPICAL
1. Retainer
2. Spring
3. Pins
– Remove the brake pads no. 9.
356 mmr2005-090
Ваш отзыв будет первым