- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 284
Section 06 ENGINE MANAGEMENT (SDI)
Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
R1503motr182A
5
19
Using a multimeter, recheck resistance value be-
tween terminals 5 and 19.
If resistance value is correct, try a new ECM. Refer
to ECM REPLACEMENT procedures elsewhere in
this section.
If resistance value is incorrect, repair the connec-
tors or replace the wiring harness between ECM
connector and the CPS.
Replacement
Disconnect connectors and remove the rewind
starter, then the magneto flywheel. Refer to
MAGNETO SYSTEM.
Remove CPS.
1
A32C9VA
1. CPS inside crankcase
When installing new CPS apply Loctite 5910
(P/N 293 800 081) between CPS and crankcase.
Torque to 8 N•m(71lbf•in).
Reinstall remaining removed parts.
AIR TEMPERATURE SENSOR
(ATS)
A33I0IA
1
1. Air temperature sensor (ATS)
Resistance Test
Disconnect the plug connector from the ATS and
check the resistance of the sensor itself.
Refer to TEMPERATURE SENSOR TABLE at the
beginning of this section to find the corresponding
resistance value for this sensor temperature.
If out of specification, replace the sensor.
If resistance tests good, reconnect the ATS and
disconnect the connector A on the ECM.
R1503motr186A
7
21
Using a multimeter, recheck resistance value be-
tween terminals 7 and 21.
If resistance value is correct, try a new ECM. Refer
to ECM REPLACEMENT procedures elsewhere in
this section.
mmr2005-081 269
Ваш отзыв будет первым