- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1331
Section 08 ELECTRICAL
Subsection 06 (TESTING PROCEDURE)
A32E3SA
1
2
TYPICAL — 12-VOLT BATTERY PLUGGED TO BUZZER
1. Buzzer positive tab
2. Buzzer negative tab
A continuous sound should be heard. if not, re-
place the buzzer with a new one.
4-Stroke Engines
Using jumper wires, connect battery positive post
to buzzer positive tab.
Connect battery negative post to buzzer negative
tab. See next photo.
CAUTION: To avoid buzzer damage, ensure
that polarity is respected.
A32E3TA
1
2
TYPICAL — 12-VOLT BATTERY PLUGGED TO BUZZER
1. Buzzer positive tab
2. Buzzer negative tab
An intermittent sound should be heard. If not, re-
place the buzzer with a new one.
LIGHTING GENERATOR COIL
VOLTAGE TESTING
– Disconnect housing from engine (YELLOW
wires).
– Connect multimeter probes to YELLOW wires,
then place selector switch to Vac and scale to
0.00.
– Activate the manual starter and check values
indicated by the multimeter.
– Repeat operation 3 times.
A05E0EA
TYPICAL
– Compare readings with those appearing in the
LIGHTING table.
CONCLUSION
If none of the above testing operations produced
valid results, it is strongly recommended to keep
on testing according to the list appearing in the
RESISTANCE column of IGNITION or LIGHTING
table.
When using the tables, make sure to follow these
guidelines:
NOTE: Stop switches include the ignition switch,
thetethercordswitchandtheenginecut-out
switch.
It is important to take note that voltage measure-
ments must be taken while starting the vehicle us-
ing the manual starter.
Voltages obtained upon starting are proportional to
the force applied onto the manual starter. A low
voltage is therefore normal under a low cranking
force.
mmr2005-047 473
Ваш отзыв будет первым