- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1207
Section 07 TRANSMISSION
Subsection 01 (DRIVE BELT)
NOTE: Turn Allen screws 1/4 turn at a time, then
rotate driven pulley to allow drive belt to settle in
pulley. Check height, repeat as required.
A06D20A
+-
1
TYPICAL
1. Allen screws with jam nuts
Allen screws must be restrained while tightening
jam nut to prevent throwing adjustment out. Use
drive belt tension adjuster (P/N 529 008 700).
A06D21A
529 008 700
TYPICAL
All Models
Vary pulley distance — within tolerances — to ob-
tain proper drive belt height.
DRIVE BELT DEFLECTION
MEASUREMENT (REFERENCE
ONLY)
IMPORTANT: The drive belt deflection will be
automatically set after performing the pulley dis-
tance and belt height adjustments. The following
procedure will confirm proper pulley distance and
belt height adjustment.
NOTE: To obtain an accurate drive belt deflection
measurement, it is suggested to allow a break-in
period of 50 km (30 mi).
Before checking the belt deflection, ensure that a
good-condition proper belt (Refer to the APPLICA-
TION CHART) is installed.
Adjust pulley distance and alignment. Refer to
PULLEY DISTANCE AND ALIGNMENT.
To obtain maximum vehicle performance, the belt
tension must be adjusted according to specifica-
tions shown in the accompanying chart.
MODEL
DEFLECTION
†
mm (in)
FORCE
kg (lb)
Tundra
32 ± 5
(1.260 ± .197)
6.8 (15)
All models
(except Tundra)
32 ± 5
(1.260 ± .197)
11.5 (25)
† FOR REFERENCE ONLY
To Check Tension
Position a reference rule on drive belt.
Wooden Stick and Spring Scale Method
A00D05A
1
1. Mark specified deflection
Using spring scale and stick, apply specified force
on drive belt halfway between pulleys as shown.
mmr2005-034 343
Ваш отзыв будет первым