- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 748
Section 06 DRIVE SYSTEM
Subsection 06 (CHAINCASE)
Check if the bearing turns smoothly and freely.
Replace bearing if any damage is detected.
Removal
Remove the countershaft.
Install the countershaft bearing remover/installer
(P/N 529 036 010) on the end of countershaft to
remove the bearing.
A35D0PA
3
2
1
1. Countershaft
2. Countershaft bearing
3. Countershaft bearing remover/installer
Remove bearing and its shim(s) no. 37.
Discard the bearing.
CAUTION: Never use a countershaft bearing a
second time, each time when it is removed it
must be replaced by a new one.
Installation
NOTE: If a new countershaft or a new bearing
support is installed, it will be necessary to mea-
sure shims thickness between bearing and coun-
tershaft shoulder.
Shimming Procedure
To perform the measurement of shims, install the
countershaft measurement tool (P/N 529 036 009)
instead of the countershaft bearing no. 36 and in-
stall the bearing flange no. 35.
A35D0QA
1 2
1. Countershaft measurement tool
2. Bearing flange
CAUTION: The countershaft measurement tool
is a countershaft bearing modified. Never use
the tool instead of the bearing. Damages to
the countershaft, support and chaincase could
occur.
Using a feeler gauge, measure the gap between
inner race of bearing and countershaft shoulder.
A35D0RA
1
2
1. Bearing inner race
2. Countershaft shoulder
Round up or down to the nearest 0.5 mm (.020 in).
Use the following table to select the proper
shim(s).
SHIM CHART
SHIM NUMBER
SHIM THICKNESS
mm (in)
504 112 000 0.42 ± 0.05 (.017 ± .002)
417 300 265 1.02 ± 0.10 (.040 ± .004)
417 300 252 2.06 ± 0.15 (.081 ± .006)
Countershaft Bearing Installation
Remove countershaft measurement tool from
countershaft.
230 mmr2005-136
Ваш отзыв будет первым