- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 917
Section 02 TROUBLESHOOTING GUIDE
Subsection 05 (ELECTRICAL SYSTEM)
Symptom: HEADLAMP DIMING. (cont’d)
4. Verify if there is an interconnection between AC and DC current (fan-cooled models).
- Faulty installation of optional equipment. Find optional equipment connected directly to DC
ground (BK wire or chassis) or to any DC hot wire (RD, RD/BU). Disconnect and reconnect to AC
current (YL and YL/BK wires).
5. Verify if optional electric accessories are overloading the magneto/generator.
- Excessive electrical load to magneto/generator. Reduce the electrical load by removing excess
accessories. Reconnect as recommended by manufacturer.
6. Hot Grips brand: Verify if they were connected in parallel by mistake.
- Excessive electrical load to magneto/generator. Reconnect as recommended by manufacturer.
7. Bombardier heating grips: Verify if the return wires of the elements were grounded to the
chassis by mistake.
- Faulty installation of optional equipment. Reconnect as recommended by manufacturer.
8. Verify if heating grips installation overloads the magneto/generator capacity.
- Excessive electrical load to magneto/generator. Reduce the electrical load by removing acces-
sories.
Symptom: FALSE FUEL AND/OR TEMPERATURE GAUGE READINGS.
1. Verify if gauge was connected on DC current by mistake (in case of optional installation).
- Faulty installation of optional equipment. Find optional wires connected directly to DC ground
(BK wire to chassis) or to any DC hot wire (RD, RD/BU). Disconnect and reconnect to AC current
(YL and YL/BK wires).
2. Verify sender unit for resistance variation when moving float arm.
- Defective or damage part. Replace sender unit.
3. Verify sender unit for free movement and/or correct arm position.
- Defective or damaged part. Correct or replace sender unit.
4. Verify sender unit/gauge wiring harness condition.
- Heating, rotating or sharp part in contact with harness. Improper harness routing. Replace or
repair damaged wires. Reroute where necessary.
Symptom: WITH ENGINE IDLING NO ELECTRICAL ACCESSORIES WORK.
1. Check idle speed.
- Too low idle speed. Readjust to specifications.
2. Verify regulator.
- Faulty regulator. Replace.
Symptom: BRAKE LIGHT REMAINS ON.
1. Check if bulb is properly installed.
- Bulb is not installed correctly (contact elements are reversed). Install bulb correctly.
2. Check brake switch.
- Switch contact remains closed. On mechanical brake if brake switch is in good condition, adjust
brake cable or brake switch. On hydraulic brake, replace brake switch.
3. Check wiring harness.
- Shorted wiring harness. Replace or repair wiring harness.
mmr2005-008 41
Ваш отзыв будет первым