- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 147
Section 03 ENGINES
Subsection 06 (BOTTOM END)
A33C15A
PTO SIDE BEARING FILLED WITH ISOFLEX GREASE
With the syringe, fill the outer ball bearing and in-
ner side of outer seal with 40 to 45 mL of Isoflex
grease.
A33C16A
BALLS COATED WITH A SEAM OF GREASE
A33C17A
TYPICAL — FILL WITH GREASE AND SET IN PLACE
Apply 6 mL of grease to MAG side outer bearing.
NOTE: If replaced with new bearing, do not apply
grease as new bearings come with grease already
applied.
Crankcase Assembly
IMPORTANT: The total assembly sequence, in-
cluding sealing compound spreading, screwing
and torquing of bolts according to the proper
sequence, must be performed within 10 minutes.
Do not wait between each bolt torquing. All bolts
mustbetorquedinarow.
Before screwing both parts of crankcase, seal it
with a Loctite 5910 (P/N 293 800 081).
NOTE: It is recommended to apply this specific
sealant as described here to get an uniform appli-
cation without lumps. If you do not use the roller
method, you may use your finger to uniformly dis-
tribute the sealant.
CAUTION: Do not use Loctite Primer N with
the Loctite 5910. Using these products or non
silicone-based sealant over a previously sealed
crankcase with Loctite 5910 will lead to poor
adhesion and possibly a leaking crankcase.
These products are chemically incompatibles.
Even after cleaning, the Loctite 5910 would
leave incompatible microscopic particles.
mmr2005-073 127
Ваш отзыв будет первым