- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1027
Section 03 ENGINES (2-STROKE)
Subsection 09 (REWIND STARTER)
INSPECTION
NOTE: Due to dust accumulation, rewind starter
must be periodically cleaned, inspected and relu-
bricated.
CAUTION: It is of the utmost importance that
the rewind starter spring be lubricated peri-
odically using specific lubricant. Otherwise,
rewind starter component life will be short-
ened and/or rewind starter will not operate
properly under very cold temperatures.
Check if rope no. 6 is fraying, replace if so.
When pulling starter grip, mechanism must en-
gage within 30 cm (1 ft) of rope pulled. If not, dis-
assemble rewind starter, clean and check for dam-
aged plastic parts. Replace as required, lubricate,
reassemble and recheck. Always replace O-ring
no. 11 every time rewind starter is disassemble.
When releasing starter grip, it must return to its
stopper and stay against it. If not, check for proper
spring preload or damages. Readjust or replace as
required.
When pulling starter grip 10 times in a row, it must
return freely. If not, check for damaged parts or
lack of lubrication. Replace parts or lubricate ac-
cordingly.
REMOVAL
Using a small screwdriver, extract rope knot from
starter grip no. 15. Cut rope close to knot. Tie a
knot near starter.
Remove screws no. 2 securing rewind starter
no. 1 to engine then remove rewind starter.
Fan Cooled Models Only
Remove pump from rewind starter cover.
ROPE REPLACEMENT
Fan Cooled Models Only
Completely pull out rope. Hold rewind starter in a
vise.
A03C3DA
12
1. Rope exit hole
2. Key to be removed
With a long thin pin punch inserted through rope
exit hole, push key no. 7. Remove key and rope.
Install a new rope and lock it using key no. 7.
NOTE: When rope is completely pulled out, spring
preload is 4-1/2 turns.
Liquid Cooled Models Only
Pull out rope. Hold rewind starter in a vise. Slide
rope and untie the knot. Pull out the rope com-
pletely.
1
A32C6GA
1. Knot to be untied
NOTE: When rope is completely pulled out, spring
preload is 4-1/2 turns.
156 mmr2005-018
Ваш отзыв будет первым