- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 723
Section 06 DRIVE SYSTEM
Subsection 03 (DRIVEN PULLEY)
Remove the rollers axles in sliding half no. 16 by
unscrewing the roller axle screws no. 8.Heat
screws to break the threadlocker.
CLEANING
Pulley Halves
Using a paper towel with pulley flange cleaner
(P/N 413 711 809), clean pulley halves.
If necessary, use a fine steel wool and a dry cloth
to remove a stubborn deposit.
Bushings and Cam
During break-in period (about 10 hours of use),
teflon from bushing no. 12 and no. 13 moves to
cam or shaft surface. A teflon over teflon running
condition occurs, leading to low friction. So it is
normal to see gray teflon deposit on cam or shaft.
Do not remove that deposit, it is not dust.
When a dust deposit has to be removed from the
cam or the shaft, use dry cloth to avoid removing
transferred teflon.
INSPECTION
NOTE: Inner flanges, threads, countershaft and all
surfaces which have contacts with other moving
parts must be free of dust, scratches or rust.
Pulley Halves
Check pulley halves for marks or scratches.
Check splines in fixed half pulley no. 14.
Bushings
Using a dial bore gauge, measure the inner diame-
ter of small and large bushings no. 12 and no. 13.
Measuring point must be at least 5 mm (1/4 in)
from bushing edge.
A03D1OA
BUSHING SERVICE LIMIT
Small bushing
38.30 mm (1.508 in)
Large bushing 108.2 mm (4.260 in)
Replace the bushing if the measurement is out of
specification. Refer to BUSHING REPLACEMENT
at the end of this section.
Rollers
Check the rollers no. 7 for flat spots, cracks or
other visible damages.
Measure inner and outer diameter of rollers.
A35D13A
B
A
A. Inner diameter
B. Outer diameter
204 mmr2005-133
Ваш отзыв будет первым