- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 338
Section 08 DRIVE SYSTEM
Subsection 02 (DRIVE PULLEY)
CAUTION: If another tool than a heat gun is
used, do not exceed 150°C(300°F).
NOTE: The ring gear removal is not necessary to
disassemble the drive pulley.
Unscrew nut no. 5. Remove washer no. 6.
Remove the drive puller cap no. 7.Checkfor
alignment marks for proper indexing at reassem-
bly.
A03D2IA
1
1. Alignment marks
Identify blocks no. 8 and their respective positive
positions for reassembly.
A05D0LA
1
1
1. Identify
Remove blocks with their calibration weights.
Install the spring cover tool (P/N 529 027 300) with
the drive pulley puller (P/N 529 022 400) on spring
cover no. 9.
529 027 300
A03D2HA
2
1
1. Drive pulley puller tool
2. Spring cover tool
Screw puller (hand tight) to hold spring cover and
remove screws no. 10 holding spring cover.
Slowly unscrew puller to release spring pressure.
Remove spring cover no. 9,springno. 11 and
spring seat no. 12.
CLEANING
Clean pulley faces and shaft with fine steel wool
and clean dry cloth. Clean sliding half bushing
with clean dry cloth.
INSPECTION
Check surface of sliding half no. 13 and fixed half
no. 14 for scratches, excessive wear or other
damages. Replace if necessary.
Check sliding half for excessive lateral play and
fixed half shaft for scratches. Replace as required.
ASSEMBLY
Install spring seat no. 12 then the spring no. 11
and its cover no. 9.
326 mmr2005-087
Ваш отзыв будет первым