- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1039
Section 03 ENGINES (2-STROKE)
Subsection 10 (FUEL SYSTEM)
A00C1TA
1
2
3
CENTER POST TYPE
1. Throttle cable
2. Needle retaining plate
3. Throttle slide
Make sure the nylon packing no. 4 is installed on
all applicable throttle slides.
CAUTION: Serious engine damage can occur if
this notice is disregarded.
2
3
4
5
1
A00C3MA
CENTER POST TYPE
1. E-clip
2. Needle retaining plate
3. Screw
4. Needle
5. Nylon packing
Using a drill bit as a gauge, adjust throttle slide
height (see following table) by turning idle speed
screw no. 7. Throttle slide height is measured on
outlet side of carburetor (engine side).
NOTE: Make sure that throttle cable does not hold
throttle slide. Loosen cable adjuster accordingly.
Throttle cable adjustment will be done during ad-
justment of throttle-slide-to-cover free play.
Final idle speed adjustment (engine running at idle
speed) should be within 1/2 turn of idle speed
screw from preliminary adjustment.
MODELS
THROTTLE
SLIDE HEIGHT
± 0.1 mm ( ± .004 in)
Tundra Skandic WT/
SWT/WT LC/ SUV 550/
SUV 600
1.5 (. 059)
Skandic LT 1.3 ( .051)
A01C3NA
1
TYPICAL
1. Drill bit used as gauge for throttle slide height
INSTALLATION
CAUTION: Never allow throttle slide(s) to snap
shut.
Prior to installing carburetor, adjust air screw and
preliminary idle speed as described above.
To install carburetor on engine, inverse removal
procedure.
However, pay attention to the following:
On applicable models, make sure to align tab of
carburetor and air intake silencer (if applicable)
with notch of adaptor(s). On applicable models,
install adaptor with up mark facing up.
CAUTION: The rubber flange must be checked
for cracks and/or damage. At assembly, the
flange must be perfectly matched with the air
intake manifold or severe engine damage will
occur.
168 mmr2005-019
Ваш отзыв будет первым