Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 240
Section 05 ENGINE MANAGEMENT (POWER TEK)
Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
If resistance value is incorrect, repair the connec-
tors or replace the wiring harness between ECM
connector and the CTS.
CTS Sensor for Temperature Gauge
Disconnect sensor connector and measure resis-
tance value between BLACK and VIOLET wires of
sensor.
If resistance value is incorrect, replace CTS sen-
sor.
If resistance value is correct, check continuity of
circuit and repair wiring harness/connectors.
Replacement
Lift rear of vehicle and securely support.
Disconnect CTS connector and remove CTS.
Install the new CTS and torque to 12 N•m
(106 lbf•in).
Reinstall remaining removed parts.
Refill engine coolant. If an important quantity of
coolant spilled, bleed cooling system. Refer to
LIQUID COOLING SYSTEM section.
AIR PRESSURE SENSOR (APS)
Sensor is integrated in ECM.
A33C52A
1
2
1. ECM
2. Air pressure sensor (APS)
Dynamic Test
Connect vehicle communication kit (VCK) and use
B.U.D.S. software.
Look atmospheric pressure in Monitoring tab of
B.U.D.S. It should show the actual pressure. Oth-
erwise, perform the following.
A33C5DA
mmr2005-107 223
Ваш отзыв будет первым