- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 354
Section 08 DRIVE SYSTEM
Subsection 03 (DRIVEN PULLEY)
DRIVEN PULLEY BUSHING WEAR LIMIT
mm (in)
Small bushing 38.30 (1.508)
Large bushing 108.2 (4.260)
Slider Shoe
Black slider shoe = forward.
Red slider shoe = reverse.
Check cam slider shoes no. 10 and no. 11 for
wear. Replace when inside edge thickness of cam
slider shoe slope base is worn to 1 mm (.039 in)
or less.
2
1
A15D0OA
3
1. Measure thickness of slope base here
2. Sliding pulley side
3. Slope base
BUSHING REPLACEMENT
Large Bushing
Remove Allen screws if applicable. Heat to break
Loctite bond.
Install the support plate included in the large bush-
ing extractor (P/N 529 031 100) inside sliding half.
Place the large bushing extractor (P/N 529 035
575) below bushing.
A03D1WB
2
1
TYPICAL
1. Support plate
2. Extractor
Mount screw head of the clutch spring compres-
sor (P/N 529 035 524) in a vise.
Turn pulley half by hand to extract old bushing.
Before bushing installation, file sliding half bore to
remove burrs from crimping areas.
Coat bushing outside diameter with Loctite 609
(P/N 413 703 100). Place new bushing on sliding
half and slightly tap to engage squarely the bush-
ing in the sliding.
ASSEMBLY
Cam Slider Shoe
When replacing slider shoes no. 10 and no. 11,al-
ways install a new set (3 shoes) to maintain equal
pressure on the cam.
Install slider shoes as per following photo. Red
slider shoes are being used for reverse and black
ones for forward.
342 mmr2005-088
Ваш отзыв будет первым