- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1102
Section 04 ENGINE (4-TEC)
Subsection 06 (CRANKSHAFT/DRIVE GEARS)
Location Pins
1
R1004motr06A
1. Location pins
NOTE: Inspect all pins for wear and damage. The
pins are firmly pressed into the crankcase but may
work loose during the course of time. If the pins
can be rotated, there is no need for repair work.
Installation
The installation is essentially the reverse of the re-
moval procedure, but pay attention to the follow-
ing details.
NOTE: Adequately oil all components prior to in-
stallation. The oil pump gears and the crankshaft
drive gear do not need to be oiled.
The generator gear and the double gear must be
installed at the same time on their respective lo-
cation pin.
Torque crankshaft nut no. 9 to 80 N•m(59lbf•ft).
TRIGGER WHEEL
The trigger wheel is located on the engine PTO
side behind the PTO cover.
1
R1004motr07A
1. Trigger wheel
Removal
Remove:
– oil tank (refer to LUBRICATION SYSTEM)
– PTO cover (refer to CRANKCASE)
– trigger wheel screws no. 6 and pull trigger
wheel no. 5.
Inspection
NOTE: Refer to COMPONENT INSPECTION AND
ADJUSTMENT in ENGINE MANAGEMENT sec-
tion.
Installation
For installation, reverse the removal procedure.
Torque trigger wheel screws to 7 N•m(62lbf•in).
CRANKSHAFT
Removal
Remove:
– drive gears (refer to DRIVE GEARS above)
– crankcase (refer to CRANKCASE)
– crankshaft no. 1
236 mmr2005-026
Ваш отзыв будет первым