- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo SUMMIT 2005, страница 1346
Section 09 REAR SUSPENSION
Subsection 02 (ARTICULATING SLIDE SUSPENSION)
REMOVAL
Release track tension.
Lift rear of vehicle and support it off the ground.
Unbolt front arm then rear arm.
Self-Locking Screws
CAUTION: These self-locking screws must al-
ways be replaced by new ones every time they
are removed.
NOTE: To prevent axle from turning when un-
screwing self-locking screws, proceed as follows:
– Remove one self-locking screw then install a
10 mm shorter non-self-locking one in place.
Torque as specified in exploded view.
– Remove the opposite self-locking screw.
– Remove the temporary installed non-self-
locking screw.
– If it doesn't work, heat bolt head to melt thread-
locker.
Remove suspension assembly.
A22F1EA
DISASSEMBLY AND ASSEMBLY
1, Extension
Remove nuts and conical washers from the eye
bolt adjuster. Remove bolt retaining eye bolt ad-
juster to support.
Remove rear idler wheel on appropriate side.
Remove idler wheel from support.
Unbolt extension from its support.
A22F19A
1
1. Support
2, Conical Washer
At installation, position conical washers as shown.
A22F1AA
1122333411
WASHER QUANTITY AND MOUNTING POSITION
A22F1BA
Tightennut3/4turnaftercontactingwashersfor
better deep snow performance. Maximum pre-
load is 3 turns after nut touching washers. This
last adjustment is for trail riding with or without a
load and for pulling a load.
490 mmr2005-049
Ваш отзыв будет первым