- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 764
Section 07 REAR SUSPENSION
Subsection 01 (SC SUSPENSION)
AXLE SELF-LOCKING SCREWS
REMOVAL
CAUTION: These self-locking screws must al-
ways be replaced by new ones everytime they
are removed.
NOTE: To prevent axle from turning when un-
screwing self-locking screws, proceed as follows:
– Remove one self-locking screw then install a
10 mm shorter non-self-locking one in place.
Torque as specified in exploded view.
– Remove the opposite self-locking screw.
– Remove the temporary installed non-self-lock-
ing screw.
– If it doesn’t work, heat bolt head to melt thread-
locker.
REAR AXLE REMOVAL
Lift rear of vehicle and support it off the ground.
Remove screws on rear axle.
Completely loosen track tension.
A33F57A
1
1. Completely loosen track tension
Remove the following on each side of vehicle:
– rear idler wheel
– idler wheel bearing protector
– idler wheel spacer.
1
A35F09A
2
3
REMOVE THE FOLLOWING
1. Idler wheel
2. Bearing protector
3. Spacer
A33F5JA
TYPICAL — PULL OUT REAR AXLE
REAR AXLE INSTALLATION
Installation is the reverse of removal procedure.
REAR SHOCK ABSORBER
REMOVAL
Lift rear of vehicle and support it off the ground.
Remove shock upper and lower bolt and nut
NOTE: If necessary, to ease shock removal, un-
fasten one end of stopper straps to release shock
pressure.
Remove rear shock absorber.
mmr2005-147 247
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0