- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 1197
Section 06 ENGINE MANAGEMENT (4-TEC)
Subsection 03 (COMPONENT INSPECTION AND ADJUSTMENT)
Voltage Test (harness)
Disconnect the connector from the CAPS.
Install the tether cord cap, then depress the cut-
out switch and push start button momentarily to
activate the ECM.
Probe pin 3 of CAPS connector (wiring harness
side) and battery ground.
– If 12 V is read, check continuity of circuits A-20
and A-34. If test is good, perform the CAPS
voltage test as explained below. If CAPS tests
good, try a new ECM.
R1503motr183A
20
34
ECM CONNECTOR
– If 12 V is not read, check continuity of circuit
between pin 3 of CAPS connector and the cor-
responding fuse. Otherwise, repair wiring har-
ness.
Remove the CAPS from the cylinder head.
Set up the following electric circuit to perform the
voltage test.
R1503motr184A
123
CAPS PIN-OUT
CAPS
1200 W
123
12 V
+
-
V
R1503motr208A
Voltmeter
Touch the CAPS with a conductor (ex.: screwdriv-
er) and look if the voltage at the multimeter switch-
es from 12 V to less than 1 V.
mmr2005-032 333
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0