- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 1067
Section 04 ENGINE (4-TEC)
Subsection 04 (LUBRICATION SYSTEM)
NOTE: Oil pressure switch works between 20 kPa
(2.9 PSI) and 40 kPa (5.8 PSI).
The engine oil pressure should be within the fol-
lowing values.
OIL PRESSURE 1300 RPM 7250 RPM
MINIMAL
150 kPa
(22 PSI)
400 kPa
(58 PSI)
NOMINAL
200 kPa
(29 PSI)
450 kPa
(65 PSI)
MAXIMAL
250 kPa
(36 PSI)
550 KPa
(80 PSI)
If the engine oil pressure is out of specifications,
check the points described in troubleshooting sec-
tion.
To install oil pressure switch, reverse the removal
procedure.
NOTE: Fit oil pressure switch with Loctite 243
(P/N 293 800 060).
OIL CHANGE
Removal
Place a drain pan under the engine drain plug area.
Cleanthedrainplugarea.
Unscrew drain plug no. 45 then remove dipstick
no. 16.
1
R1004motr39A
2
1. Drain plug
2. Gasket ring
– Unscrew retaining screw no. 9 to drain the oil
filter housing.
– Wait a while to allow oil to flow out of oil filter.
Inspection
Oil condition gives information about the engine
condition. See TROUBLESHOOTING section.
Installation
The installation is the reverse of removal proce-
dure. Pay attention to the following details.
NOTE: At installation, remember to replace the
gasket ring no. 44 of the drain plug.
Torquedrainplugto55N•m(40lbf•ft).
System Capacity
Refer to TECHNICAL DATA.
NOTE: After filling, warm up the engine to 80°C
(176°F) and check the oil level with the dipstick.
Refer to OIL LEVEL CHECK above.
OIL FILTER
Removal
Remove:
– engine oil (refer to OIL CHANGE)
– oil filter screw no. 9
– oil filter cover no. 7
– oil filter no. 5.
1
R1004motr40A
3 2 3 4
1. Oil filter screw
2. Oil filter cover
3. Gaskets
4. Oil filter
mmr2005-024 199
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0