- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 181
Section 03 ENGINES
Subsection 10 (OIL INJECTION SYSTEM)
Liquid-cooled Models
Remove:
– air box
– carburetor or throttle body
– screw no. 16.
Unplug all hoses connected to oil pump no. 4.
NOTE: Mark hose locations for installation.
Disconnect the oil pump cable.
Oil Pump Gear
Fan-cooled Models
Remove the oil pump from engine.
To remove the gear retaining nut no. 17,firstex-
tract the needle roller no. 18 with pliers then lock
gear in place using the gear holder (P/N 420 876
695).
A10C01A
420 876 695
TYPICAL
Separate the oil pump from the pump mounting
flange no. 14 by removing oilpump screws no. 16.
Check Valve
Liquid-cooled Models
NOTE: Before removing check valve no. 5,check
its operation. Refer to the end of this section.
Remove air box and carburetor or throttle body.
Clean check valve area to remove oil or dirt.
Heat check valve no. 5 then pull it out of
crankcase.
ASSEMBLY
CAUTION: Always bleed oil pump when the
system has been opened.
NOTE: During installation, always check for spring
clips no. 19 tightness.
Injection Oil Reservoir
For installation, reverse the removal procedure.
Injection Oil Level sensor
For installation, reverse the removal procedure.
Injection Oil Filter
For installation, reverse the removal procedure.
NOTE: The filter must be installed with the arrow
pointing toward the pump.
Injection Oil Pump
For installation, reverse the removal procedure.
However, pay attention to the following.
Torque the screws no. 16 to 5 N•m(44lbf•in).
Make sure cable barrel is well seated in oil pump
lever.
Secure barrel with plastic washer and circlip.
Install cable lock washer on left side of support.
Verify cable and oil pump lever operation then ad-
just cable.
Oil Pump Gear
Fan-cooled Models
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following
details.
At gear assembly, apply a light coat of
Molykote 111 (P/N 413 707 000) on gear teeth.
The needle roller no. 18 must be engaged as deep
as possible in the pump mounting flange.
Check Valve
Liquid-cooled Models
Prior to coating it with Loctite, make sure check
valve body is clean and dry. Clean from dirt or oil, if
any, with pulley flange cleaner (P/N 413 711 809).
Apply Loctite 648 (green) (P/N 413 711 400) on
the outer diameter of the check valve (machined
section). Take care that Loctite is ONLY in this
area.
mmr2005-076 161
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0