- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 782
Section 07 REAR SUSPENSION
Subsection 02 (SC 4 SUSPENSION)
For pivot arm removal, remove the following:
– bolts, nuts and washers holding pivot arm to
runners.
A33F5YA
1
2
4
6
3
5
SUSPENSION REMOVED FOR CLARITY
1. Shock upper bolt and nut
2. Rear springs
3. Rear arm/pivot arm screws and washers
4. Rear arm
5. Pivot arm/runner bolts, nuts and washers
6. Pivot arm
REAR ARM/PIVOT ARM
INSTALLATION
Installation is reverse of removal procedure. Pay
attention to the following details.
Pivot arm grease fitting must be towards the front
of the vehicle.
At installation, rear arm stroke limiter must be on
rear side.
Insert dowel pin into pivot arm hole, dowel pin
must exceed block guide by 2 to 2.3 mm (.079 to
.091 in).
Respect the following tightening torque specifica-
tions.
DESCRIPTION TIGHTENING TORQUE
Pivot arm/runners nut 25 N•m(18lbf•ft)
Locking ring set screw 2.5 N•m(22lbf•in)
BLOCK INSTALLATION
Both blocks are identified R or L (right or left) and
have position number (from 1 to 4). At installation
make sure to install proper block on proper side
with the same adjustment position on both sides.
A33F60A
1
2
TYPICAL
1. Blocks are identified R or L (right or left)
2. Blocks position number (from 1 to 4)
IDLERWHEELSINSTALLATION
Refer to illustration for idler wheels position at in-
stallation.
A33F5ZA
1
2
1. RH side wheels position
2. LH side wheels position
STOPPER STRAP
Inspect strap for wear or cracks, bolt and nut for
tightness. If loose, inspect hole for deformation.
Replace as required.
mmr2005-139 265
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0