- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 1224
Section 07 TRANSMISSION
Subsection 02 (DRIVE PULLEY)
Remove all hardened oil deposits that have baked
on crankshaft and pulley tapered surfaces with
coarse or medium steel wool and/or sand paper
no. 600.
CAUTION: Do not use any other type of abra-
sive.
Reclean mounting surfaces with paper towel and
cleaning solvent.
Wipe off the mounting surfaces with a clean, dry
paper towel.
CAUTION: Mounting surfaces must be free of
any oil, cleaner or towel residue.
7,20, Bushing
Only use petrol base cleaner when cleaning bush-
ings.
CAUTION: Do not use acetone to clean bush-
ing.
INSPECTION
Drive pulley should be inspected annually.
16,17, Thrust Washer and Roller
Check roller for roundness of external diameter.
Check thrust washer for thickness wear. Replace
as required.
CAUTION: Ensure rollers are in good condition.
Replace as required.
9,12, Fitting Bolt Ass’yand
Flanged Bushing
Check for wear, replace as required.
24,25, O-Ring and Slider Shoe
Check if O-rings are cracked, cut or crushed. Re-
place as required.
Check slider shoes for wear. Replace if groove is
not apparent on top.
5,29, Fixed Half and Governor Cup
Inspect splines and free play between both parts.
Maximum free play is 0.5 mm (.020 in) measured
at calibration screw radius. Replace if required.
7,20, Sliding Half and Spring
Cover Bushing
Visually inspect coating. Replace if worn.
Sliding Half Bushing Replacement
NOTE: In case of worn out bushing, it is advisable
to replace whole sliding half ass’yasreplacingjust
the bushing may reduce the drive pulley perfor-
mance.
Remove circlip from the sliding half.
A32D2TA
1
1. Circlip
Secure the pulley spring compressor (P/N 529 035
524) in a vise mount tool (P/N 529 031 200) and the
sliding half ass’yonit.
A32D2UA
529 031 200
529 035 524
Use the large bushing extractor tool (P/N 529 035
931) to press out old bushing.
NOTE: Make sure to use the large bushing extrac-
tor tool (P/N 529 035 931) as marked; to remove
the bushing press using the side marked “OUT”,
as shown below in the picture.
360 mmr2005-035
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0