- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 951
Section 03 ENGINES (2-STROKE)
Subsection 02 (443 AND 552 ENGINES)
NOTE: Engine must be removed from chassis to
perform the following procedures.
Remove engine from chassis.
Remove fan guard, rewind starter, starting pulley,
trigger coil wire from 4-connector housing, mag-
neto flywheel then fan housing.
Remove stator plate.
CLEANING
Discard all seals, gaskets and O-rings.
Clean all metal components in a non-ferrous met-
al cleaner. Use Loctite Chisel (P/N 413 708 500)
accordingly.
Remove all trace of Loctite from crankshaft taper.
Remove old sealant from crankcase mating sur-
faces with Loctite Chisel (P/N 413 708 500).
CAUTION: Never use a sharp object to scrape
away old sealant as score marks incurred are
detrimental to crankcase sealing.
DISASSEMBLY
To remove PTO side bearing no. 3 from crank-
shaft, install half rings on the bearing.
NOTE: Remove the bearing O-ring prior to instal-
lation of half ring.
A32CB0A
2
1
1. Half ring
2. Puller ring
Apply synthetic grease (P/N 413 711 500) on the
crankshaft end and install protective cap (P/N 420
876 552).
A32CB1A
1
1. Protective cap
Using screws (P/N 420 840 681), install bearing
puller on the half rings.
A32CB2A
PULLER INSTALLED ON THE HALF RINGS
Secure the bearing puller in a vise by one of its rib.
mmr2005-011 77
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0