- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 1394
Section 10 STEERING / FRONT SUSPENSION
Subsection 02 (SUSPENSION AND SKI SYSTEM)
DISASSEMBLY
5, Shock
Lift front of vehicle and support it off the ground.
Reduce spring preload by turning adjusting ring
accordingly.
Remove lower bolt then upper bolt of shock.
For shock spring disassembly use shock spring
removal kit (P/N 529 035 504) in a vise. Mount
shock in it and turn shock so that spring coils
matched spring compressor.
Close and lock the bar. Adjust the handle at hori-
zontal position by changing the position of the cle-
vis pin.
1
A01B4LA
2
3
1. Clevis pin
2. Bar
3. Handle horizontal
Push down on the handle until it locks. Remove
spring stopper then release handle.
1, Swing Arm
Lift front of vehicle and support it off the ground.
Remove cap no. 4, circlip no. 3.
Scribe mark the steering arm and ski leg before
disassembly.
A29G0WA
Then loosen steering arm bolt and pull up steering
arm. Ski leg may fall off from swing arm.
Unbolt lower end of shock from swing arm.
Unbolt upper and lower arms.
Unbolt rear of swing arm from frame.
Pull swing arm off the vehicle.
INSPECTION
Check all rubber cushions for crack and wear. Re-
place as required.
Check straightness of ski leg no. 12 and make
sure that splines are properly interlocking with
steering arm. Replace as required.
Check for straightness of swing arm. Replace as
required.
Check for clogged grease fittings. Clean or re-
place as required.
Check skis and runners no. 10 for wear, replace
as necessary.
Check condition of ski stopper no. 9. Replace it
when deteriorated.
To check condition of shock, refer to SHOCK AB-
SORBER in INSPECTION CHAPTER.
mmr2005-054 539
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0