- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 412
Section 09 REAR SUSPENSION
Subsection 02 (SC 3 SUSPENSION)
A33F69A
1
5
2
4
3
TYPICAL
1. Shock upper bolt and nut
2. Front arm lower bolts and washers
3. Unfasten one end of stopper straps
4. Front arm upper bolts, nuts and washers
5. Front arm
FRONT ARM INSTALLATION
Installation is reverse of removal procedure.
Respect the following tightening torque specifica-
tion:
DESCRIPTION TIGHTENING TORQUE
Stopper strap(s) nuts
11 N•m(97lbf•in)
REAR ARM/PIVOT ARM REMOVAL
NOTE: Rear arm can be removed with suspension
assembly in place.
For rear arm removal, remove the following:
– shock upper bolt and nut
– throttle rods upper bolt and nut
– rear springs (refer to procedure above in this
section)
– screws and washers holding rear arm to pivot
arm.
Remove rear arm.
For pivot arm removal, remove the following:
– bolt, nut and washers holding pivot arm to run-
ners.
Remove pivot arm.
A33F6AA
1
2
5
4
7
4
3
3
6
TYPICAL
1. Shock upper bolt and nut
2. Throttle rods upper bolt and nut
3. Rear springs
4. Rear arm/pivot arm screws and washers
5. Rear arm
6. Pivot arm/runners bolt, nut and washers
7. Pivot arm
REAR ARM/PIVOT ARM
INSTALLATION
Installation is reverse of removal procedure. Pay
attention to the following details.
Both blocks are identified R or L (right or left),
see second following photo. At installation, make
sure to install proper block on proper side.
Also, note that protrusion must be positioned
above stoppers.
mmr2005-095 405
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0