- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 659
Section 04 ENGINE MANAGEMENT (SDI)
Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
TEMPERATURE SENSOR TABLE
TEMPERATURE RESISTANCE (OHMS)
CTS FOR
°C °F ATS
GAUGE ECM
85 185 21.95 282.8
90 194 19.45 244.8
95 203 17.28 212.8
100 212 180 15.4 185.6
105 221 162.4
110 230 142.7
115 239 125.9
120 248 111.5
125 257 99.02
130 266 90 88.26
135 275 78.93
140 284 70.81
145 293 63.71
150 302 57.49
The resistance value of a temperature sensor may
test good at a certain temperature but it might be
defective at other temperatures. If in doubt, try a
new sensor.
Also remember this validates the operation of the
sensor at room temperature. It does not validate
the over temperature functionality. To test it, the
sensor could be removed from the engine/air si-
lencer and heated with a heat gun while it is still
connected to the harness to see if the ECM will
detect the high temperature condition and gener-
ate a fault code.
Connector Identifications
A35C3SC
1
2
3
1. ECM A-connector
2. ECM B-connector
3. Engine/vehicle connector
ECM Connectors
The most recommended and safest method to
probe ECM connector terminals is to use the
ECM adapter (P/N 420 277 010). This tool will
prevent deforming or enlarging terminals which
would lead to bad ECM terminal contact creating
intermittent or permanent problems.
420 277 010
Disconnect the desired connector from ECM and
reconnect on the tool connector. Probe required
terminals directly in the tool holes.
138 mmr2005-126
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0