- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 108
Section 03 ENGINES
Subsection 05 (TOP END)
A02C2MA
Using square end of tool, push circlip in until it
rests in groove.
A02C2NA
1
1. Circlip in groove
Mount tool in piston making sure that circlip break
is facing down.
1
A02C2OA
TYPICAL
1. Circlip break facing down
Hold tool firmly against piston then strike on round
end of tool with a plastic hammer. Circlip will
movefromtoolgroovetopistongroove.
1
2
A01C02A
1. Piston notch
2. Circlip break at 6 o’clock
CAUTION: Circlips must not move freely in the
groove after installation. If so, replace them.
552 Engine
When reinstalling original needle bearings, make
sure that 34 needles are inserted between sleeve
and locating sleeve.
When installing a new cageless bearing, replace
half plastic cages by sleeve.
88 mmr2005-072
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0