- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 243
Section 05 ENGINE MANAGEMENT (POWER TEK)
Subsection 03 (COMPONENT INSPECTION, REPLACEMENT AND ADJUSTMENT)
A33C4XA
1
1
1. Install hose pinchers
– disconnect inlet and outlet coolant hoses from
carburetors
NOTE: Keep throttle cable installed to avoid fur-
ther adjustment.
– properly rotate and slightly pull out carburetors
to gain access to TPS
NOTE: Mark hose locations of E-RAVE solenoid
for reinstallation.
– remove solenoid screws and solenoid.
For installation, reverse the removal procedure.
Check/adjust engine idle speed.
DPM SOLENOID
Electrical Test
Connect vehicle communication kit (VCK) and use
B.U.D.S. software.
Energize Leaning valve (DPM solenoid) from Ac-
tivation tab.
A33C5JA
This will validate the solenoid mechanical and elec-
trical operation.
Listen to or touch relay to feel it clicks.
If the solenoid does not work, disconnect the con-
nector from the solenoid.
NOTE: To gain access to connector pins, unlock
connector and slide it out toward oil tank. Refer
to WIRING DIAGRAMS.
Measure voltage between pin 2 of DPM sole-
noid on harness side, and battery ground (engine
ground on manual start models).
If 12 V is read, disconnect connector from the
ECM and check continuity of circuit between pin
DA-29 and pin 1. If wire/connector tests good, try
a new ECM. Refer to ECM for replacement proce-
dures.
If it does not read 12 V, check the corresponding
fuse(s), relay and continuity of circuit DP-2. If con-
tinuity is faulty, repair/replace wire/connector.
Replacement
Refer to FUEL SYSTEM.
IGNITION COIL
A33C55A
1
RH SIDE OF VEHICLE
1. Ignition coil
The ECM energizes the primary side of ignition
coil.
Connect vehicle communication kit (VCK) and use
B.U.D.S. software.
Energize ignition coil from Activation tab.
226 mmr2005-107
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0