- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 1116
Section 04 ENGINE (4-TEC)
Subsection 07 (CRANKCASE)
Bearing Installation Procedure
NOTE: Unless otherwise instructed, never use
hammer to install plain bearings. Use press ma-
chine only.
Install plain bearings with the proper plain bearing
installer/remover (P/N 529 035 914).
Fit the plain bearings with Petamo grease (P/N 420
899 271).
NOTE: Carefully press-in the plain bearings no. 18
and no. 19 in the same direction as during disas-
sembly, from the outside towards the inside. Sup-
port PTO cover with suitable support with straight
surface, in order to prevent damage of the sealing
surface.
CAUTION: Mark position of oil bore in plain
bearing on crankcase half. Align mark on
plain bearing installer/remover with mark on
crankcase half. Wrong oil bore position will
stop oil supply to plain bearing and will dam-
age the engine.
2
1
R1004motr114A
1. PTO cover
2. Oil bore
CAUTION: The partition of the plain bearings
must be positioned between the oil return
holes (refer to no. 3 in next illustration) in the
PTO cover.
2
R1004motr115A
3 1
1. PTO cover
2. Partition
3. Oil return holes
Oil Seal Installation Procedure
NOTE: At installation, replace PTO cover oil seal
no. 20.
Push PTO cover oil seal in place by using the PTO
cover oil seal installer (P/N 529 035 910).
2
R1004motr116A
1
1. Oil seal for the PTO cover
2. Oil seal pusher (P/N 529 035 910)
Installation
For installation, reverse the removal procedu
re.
Pay attention to the following details.
NOTE: At installation, replace gasket no. 21.
Torque PTO cover screws to 9 N•
m(80lbf•in).
250 mmr2005-027
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0