Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 713
Section 06 DRIVE SYSTEM
Subsection 02 (DRIVE PULLEY)
CAUTION: Ensure rollers are in good condition.
Replace as required.
Lever Bolt and Flanged Bushing
Check the flanged bushing no. 18 for wear. Re-
place if necessary.
Check lever bolts no. 19 for wear, replace as re-
quired.
O-ring and Slider Shoe
Check if O-rings no. 20 are cracked, cut or
crushed. Replace as required.
Check slider shoes no. 9 for wear. Replace if
groove is not apparent on top.
Sliding Half and Spring Cover Bushings
Visually inspect coating of bushings no. 14 and
no. 15. Replace if worn.
Sliding Half Bushing Replacement
NOTE: In case of worn out bushing, it is advisable
to replace whole sliding half assembly as replac-
ing just the bushing may reduce the drive pulley
performance.
Remove circlip no. 21 from the sliding half.
A32D2TA
1
TYPICAL
1. Circlip
Secure the spring compressor (P/N 529 035 524)
in a vice. Mount the bushing remover/installer
(P/N 529 031 200) and the sliding half assembly
on it.
A32D2UA
529 031 200
529 035 524
TYPICAL
Use the sliding half bushing remover/installer
(P/N 529 035 931) to press out old bushing.
NOTE: Make sure to use the tool as marked; to
remove the bushing press using the side marked
“OUT”, as shown below in the picture.
A32D2VA
TYPICAL
Use a soft sand paper to clean sliding half bushing
mounting surface.
194 mmr2005-132
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
Сортировать:
по дате
c ответами
виктор
06 января 2022, Курганская
здраствуйте мануал на mxz 440 2005 год
Анатолий Миронов
04 декабря 2020, Зеленоград
здравствуй те! если есть мануал на русском для снегохода ски-дуMZX583 1997г.в. то было бы здорово если вы мне на почту прислали. Спасибо!