- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 356
Section 08 DRIVE SYSTEM
Subsection 03 (DRIVEN PULLEY)
ADJUSTMENT
Cam
Make sure to install proper cam. Refer to TECH-
NICAL DATA.
Cam angle is identified on cam.
Spring
To check spring preload adjustment, use the
spring scale hook (P/N 529 006 500) and a spring
scale.
529 006 500
Remove drive belt.
Install the hook on the sliding half. Preventing
fixed half from turning, pull sliding half with the
spring scale perpendicularly with pulley axle.
Take first measurement when sliding half begins
toturn. Rotateslidinghalfto10mm(3/8in)of
rotation. Hold spring scale at this position. Slow-
ly release tension from spring scale and take sec-
ond measurement when sliding half begins to re-
turn. Spring preload is the average measurement
between these 2.
First measurement
(when opening)
+
Second measurement
(when closing)
2
=
Spring
preload
EXAMPLE:
3.8kg(8.4lb)
(when opening)
+
3.4kg(7.5lb)
(when closing)
2
=
3.6kg(8lb)
actual
spring
preload
529 006 500
A01B18A
1
2
TYPICAL
1. Pull for the first measurement
2. Release slowly for the second measurement
To adjust spring preload, relocated spring end in
cam, moving it clockwise to increase the preload
and counterclockwise to decrease it. Refer to
TECHNICAL DATA.
NOTE: Ifthespringpreloadcannotbeadjusted,
try to relocate the other end of spring in sliding
pulley (holes A, B or C).
A18C0AA
3 2
1
4
5
6
A
C
B
LETTERS AND NUMBERS SHOWN IN ILLUSTRATION ARE
ACTUAL LETTERS AND NUMBERS EMBOSSED ON PARTS
NOTE: Always recheck torsional preload after ad-
justing.
Pulley Alignment and Drive Belt
Deflection
Refer to PULLEY ALIGNMENT and DRIVE BELT to
perform adjustments.
CAUTION: Drive belt and pulley alignment
must always be checked whenever pulleys
have been removed, replaced or disassem-
bled.
344 mmr2005-088
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0