- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 180
Section 03 ENGINES
Subsection 10 (OIL INJECTION SYSTEM)
Oil Reservoir Check Valve
It allows air to get into the reservoir. To verify this
one-way check valve, remove it along with the
hose. Make sure that it holds pressure and that
it does not let air go through.
While installing this check valve make sure that
the black side is towards the reservoir.
DISASSEMBLY
NOTE: Some oil pump components are not avail-
able as single parts.
Injection Oil Reservoir
Empty injection oil reservoir no. 1 by siphoning
injection oil.
Remove:
– air box
– upper screw no. 7 (near reservoir cap)
– rewind starter support and grip
– hose protector support
– electronic module (if the module is located on
the reservoir)
– lower nut no. 8 or screw no. 9 and no. 10.
NOTE: Cut the ties retaining the wiring harness if
necessary.
Injection Oil Level Sensor
To remove the switch no. 11, use the following
procedure.
Remove injection oil reservoir, as mentioned
above.
Unplug switch connector.
Pull oil level switch no. 7 outofreservoir.
Before replacing the injection oil level switch
no. 11, check it according to the following proce-
dure:
CAUTION: Do not remove or bend the reed
switch protective float lock. It can damage the
reed switch glass.
With the float magnet ring at the lowest position.
Using an ohmmeter, probe the connector.
1
A33D1DA
1. Float magnet at the lowest position
Reading below 0 ohm reflects the proper switch
function. Replace the oil level switch if reading
above 0 ohm.
Injection Oil Filter
Remove air box and carburetor or throttle body.
Siphon injection oil reservoir.
Disconnect oil filter hose no. 2 from the reservoir
no. 1.
Disconnect oil hoses no. 2 and no. 12 from the oil
filter no. 6 and remove it.
Injection Oil Pump
NOTE: Before removing the injection oil pump
no. 4, check its operation. Refer to CHECKING
OPERATION, above in this section.
Fan-cooled Models
Drain injection oil reservoir.
Remove the muffler.
Disconnect oil pump cable.
Install a hose pincher (P/N 295 000 076) on each
oil pump outlet hoses then disconnect them.
NOTE: Mark hoses locations for installation.
Unscrew nut no. 13.
Remove oil pump mounting flange no. 14.
Remove oil pump gear no. 5.
Remove screws no. 16.
Remove oil pump.
160 mmr2005-076
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0