- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 1068
Section 04 ENGINE (4-TEC)
Subsection 04 (LUBRICATION SYSTEM)
Inspection
Check and clean the oil filter inlet and outlet area
for dirt and other contaminations.
1
R1004motr41A
2
1. Inlet bore from the oil pump to the oil filter
2. Outlet bore to the engine oil providing system
Installation
The installation is the opposite of the removal pro-
cedure. Pay attention to the following details.
NOTE: Slightly oil the two gaskets at the top and
bottom sides of the oil filter before assembly. This
will ease assembly and prevent displacement of
the gasket during installation.
At assembly, remember to replace the two
O-rings no. 6 and no. 8 of the oil filter screw.
Slightly grease the O-ring no. 6 of the oil filter cov-
er before assembly using Molykote 111 (P/N 413
707 000). This will ease assembly and prevent dis-
placement of the gasket during installation.
Torque oil filter screw to 9 N•m(80lbf•in).
OIL TANK
Removal
First drain the lubrication system (refer to OIL
CHANGE).
Remove:
– hose clamps no. 17 and pull hoses
– oil tank screws no. 13 and no. 14 and pull oil
tank no. 10.
2
R1004motr55A
2
1
3
1. Oil tank
2. Six screws
3. Hoses
CAUTION: Make sure that the O-rings no. 11
and no. 12 do not get stuck in the crankcase.
Inspection
Inspect the oil tank for cracks/fractures or other
damage/leakage.
NOTE: If necessary, replace the oil tank.
Installation
The installation is the opposite of the removal pro-
cedure. Pay attention to the following details.
NOTE: At assembly, replace both O-rings no. 11
and no. 12.
Before assembly, slightly grease the O-rings. This
will ease assembly and prevent displacement of
the gasket during installation.
Torque oil tank screws to 9 N•m(80lbf•in)asper
following sequence.
200 mmr2005-024
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0