- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 1313
Section08ELECTRICAL
Subsection 05 (ELECTRIC STARTER)
A19E01A
Twist screwdriver to separate stop collars no. 12
thus giving access to circlip no. 13.
Remove outer collar, circlip then inner collar.
Remove overrunning clutch no. 11.
Check the wear on bushing no. 18 by measuring
theamountofradialplaybetweenthearmature
shaft and the bushing.
The radial play should not exceed 0.20 mm
(.008 in). If greater, replace the bushing. To re-
place, press out the old one toward bushing cover
and press in a new one with a bushing pusher.
The correct size of the bushing pusher to use is
givenonnextillustration.
CAUTION: Support drive housing adequately
to prevent damage when pressing bushing.
A19E0AA
B
C
D
A
D
BUSHING PUSHER
A. 16 mm (5/8 in) diameter
B. 13 mm (1/2 in)
C. 11 mm (7/16 in)
D. 11.0 mm (.433 in)
A19E0BA
1
2
3
4
1. Press-in
2. Bushing pusher
3. Bushing
4. Drive housing
Install bushing cover no. 19 then, using a punch,
stake bushing cover in place.
A19E02A
1
2
1. Stake bushing cover
2. Support
3, Bushing (end frame)
Check the wear on bushing no. 3 by measuring
the amount of radial play between the armature
shaft and the bushing.
The radial play should not exceed 0.20 mm
(.008 in). If greater, replace bushing as follows:
Using a 12 mm tap, cut threads into bushing so
that the tap contacts the end frame. Continue to
rotate tap until the bushing comes free.
454 mmr2005-046
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0