- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 406
Section 09 REAR SUSPENSION
Subsection 02 (SC 3 SUSPENSION)
AXLE SELF-LOCKING SCREWS
REMOVAL
CAUTION: These self-locking screws must al-
ways be replaced by new ones everytime they
are removed.
NOTE: To prevent axle from turning when un-
screwing self-locking screws, proceed as follows:
– Remove one self-locking screw then install a
10 mm shorter non-self-locking one in place.
Torque as specified in exploded view.
– Remove the opposite self-locking screw.
– Remove the temporary installed non-self-lock-
ing screw.
– If it doesn’t work, heat bolt head to melt thread-
locker.
REAR AXLE REMOVAL
Lift rear of vehicle and support it off the ground.
Remove screws on rear axle.
Completely loosen track tension.
A33F57A
1
TYPICAL
1. Completely loosen track tension
Pull out rear axle from RH side of vehicle.
A33F5JA
TYPICAL — PULL OUT REAR AXLE
REAR AXLE INSTALLATION
Installation is reverse of removal procedure. Pay
attention to the following details.
Hole of outer bushing must face adjustment
screw.
Make sure to reinstall washer on each side of run-
ner.
A32F12A
OUTER BUSHING POSITION
REAR SHOCK ABSORBER
REMOVAL
Lift rear of vehicle and support it off the ground.
Remove shock upper and lower bolt and nut
mmr2005-095 399
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0