- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 933
Section 03 ENGINES (2-STROKE)
Subsection 01 (277 ENGINE TYPE)
NOTE: Engine must be removed from chassis to
perform the following procedures.
CLEANING
Discard all oil seals and gaskets.
Clean all metal components in a non-ferrous metal
cleaner.
DISASSEMBLY
General
To remove drive pulley, refer to DRIVE PULLEY.
To remove magneto, refer to MAGNETO.
2,6, Crankcase Half
Heat to 110 - 120°C(230-248°F) all around
bearing seat on PTO side. Install puller (P/N 420
876 298) to plate (P/N 529 024 900) with flat
washer under screw heads and extract PTO side
crankcase half no. 1.
A05C0GA
1
M8 x 40
2
M8 x 30
1. Plate
2. Flat washer
Heat to 110 - 120°C (230 - 248°F) all around bear-
ing seat on MAG side. Install puller with plate,
long bolts M8 x 110 mm and flat washers. Extract
MAG side crankcase half no. 2.
A05C0HA
1
M8 x 110 mm
2
1. Plate
2. Flat washers
To remove seals no. 3 and 4, push from outside
the crankcase towards the inside.
To remove bearings no. 5 and 6 from crankshaft
use a protective cap and special puller as illustrat-
ed.
1
2
A00B28A
1. Protective cap
2. Special puller
INSPECTION
Refer to LEAK TEST AND ENGINE DIMENSION
MEASUREMENT.
ASSEMBLY
Install connecting rod with its lubrication slot on
big end facing exhaust side.
Smear anti-seize lubricant (P/N 293 800 070) on
part of crankshaft where bearing fits.
58 mmr2005-010
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0