- Тип техники
- Бренд
Просмотр инструкции снегоходы Ski Doo MX Z 2005, страница 712
Section 06 DRIVE SYSTEM
Subsection 02 (DRIVE PULLEY)
1
A03D3EA
1. Support guide
Install sliding half no. 8 then a second support
guide. These support guides will prevent bushing
damages.
A03D3FA
1
TYPICAL
1. Support guide
Remove 3 Allen screws no. 11 retaining spring
cover then unscrew compressor.
Remove spring cover, spring no. 12 and spring
seat no. 13.
CLEANING
Fixed and Sliding Halves
Parts must be at room temperature before clean-
ing.
Clean pulley halves and shaft with fine steel wool
and dry cloth.
Using a paper towel with pulley flange cleaner
(P/N 413 711 809), clean crankshaft tapered end
and the taper inside the fixed half of the drive
pulley, crankshaft threads and retaining screw
threads.
CAUTION: Avoid contact between cleaner and
crankshaft seal because damage may occur.
Remove all hardened oil deposits that have baked
on crankshaft and pulley tapered surfaces with
coarse or medium steel wool and/or sand paper
no. 600.
CAUTION: Do not use any other type of abra-
sive.
Reclean mounting surfaces with paper towel and
cleaning solvent.
Wipe off the mounting surfaces with a clean, dry
paper towel.
CAUTION: Mounting surfaces must be free of
any oil, cleaner or towel residue.
Bushings
Clean sliding half bushing no. 14 and spring cover
bushing no. 15 only with a petrol-based cleaner.
CAUTION: Do not use acetone to clean bush-
ing.
INSPECTION
Drive pulley should be inspected annually.
Ring Gear
Check torque of ring gear screws. If a screw
turns, verify screw surface and ring gear surface.
If surface is worn, replace ring gear and screws.
If screw is only loose, refer to ASSEMBLY for
procedure and torque.
Thrust Washer and Roller
Check rollers no. 16 for roundness of external di-
ameter. Check thrust washers no. 17 for thick-
ness wear. Replace as required.
mmr2005-132 193
Ваш отзыв будет первым
Вопросы пользователей
Поиск:
по производителю
по типу техники
по модели
Сортировать:
по дате
c ответами
0